Praktik Dasar Cisco Packet Tracer - Mengaktifkan Fungsi Routing di Switch Layer 3

 

Mengaktifkan fungsi routing di Switch layer 3 - Packet Tracer

Menambahkan IP Address ke Switch Interface #

---

Menambahkan IP Address di switch hanya bisa di konfigurasi di L3 switch, contoh beberapa seri switch antara lain, seperti seri 3560 dan 3650.

Berikut ini, fungsi yang harus kalian pahami : 

- Perintah “ip routing” berfungsi untuk menaktifkan fungsi-fungsi router ke switch. 

- Perintah “no switchport” berguna agar port pada switch bisa diberikan ip address.

Switch>enable 
Switch#configure terminal 
Switch(config)#interface fa0/1
Switch(config)#ip routing
Switch(config-if)#no switchport 
Switch(config-if)#ip address 192.168.10.1 255.255.255.0
Switch(config-if)#interface fa0/2
Switch(config-if)#no switchport 
Switch(config-if)#ip address 192.168.20.1 255.255.255.0

DHCP Server

---

Konfigurasi DHCP server pada switch konfigurasinya mirip dengan DHCP server pada router

# Menambahkan pool dhcp
Switch(config)#ip dhcp pool pool10
Switch(dhcp-config)#network 192.168.10.0 255.255.255.0
Switch(dhcp-config)#default-router 192.168.10.1
Switch(dhcp-config)#exit
Switch(config)#ip dhcp pool pool20
Switch(dhcp-config)#network 192.168.20.0 255.255.255.0
Switch(dhcp-config)#default-router 192.168.20.1
Switch(dhcp-config)#exit
# IP Address pengecualian
Switch(config)#ip dhcp excluded-address 192.168.10.1
Switch(config)#ip dhcp excluded-address 192.168.20.1
Switch(config)#

Referensi :
https://rafimf.gitlab.io/notes/network/packet-tracer/ip-interface-dhcp-server-packettracer/